• M Pump

    Simply unbolt the flight section and replace! Reduces maintenance to as little as 4 man-hours

    • No need to disconnect drive
    • Flanged drive shaft increases bearing life
    • Fast screw replacement through hopper access
    • No need to disassemble end shaft or replace bearings
    • Reduced risk of contaminating bearings and seals
    • Stub shaft, bearing and seals can be removed as assembly housings
    See Color Coded Parts Drawing
    Red: Basic Kit
    Yellow: Option To Basic Kit
    Yellow + Blue +Red = Complete Kit

  • Fuller-Kinyon Screw Pump

    Fuller®-Kinyon™ Screw Pump

    • High performance
    • Low maintenance
    • Maximum efficiency
    Fuller®-Kinyon™ Type M Pumps are constructed of cast iron and steel, and mounted on a cast iron base. Type M pumps are equipped with ball bearings that support a pump screw at both ends to help provide a smooth, balanced operation. The screw is dynamically balanced and areas of this screw, along with other parts of the pump in direct contact with the material to be conveyed, are made of hardened, wearresistant material and special hard surfacing where required. The screw is directly coupled to the driving motor but can be v-belt driven. Standard equipment on Type M pumps includes a pressurized seal and bearing assembly that extends the service life of the discharge seals by preventing the material being handled from entering the bearing area. Each pump system includes the pump, drive motor and compressed air source.